100% Free CheckPoint 156-836 Practice Test Questions and Answers 2026

Start Learning with the Latest and Real 100% Free CheckPoint 156-836 Exam Questions

Page: 1 / 17

Total 83 Questions | Updated On: May 22, 2026

Add To Cart

Question 1

While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?

A : A correction rate above 90 percent indicates a need to disable Layer 4 Distribution.

B : A correction rate approaching 100 percent of all connections is unusual. This is a cause for concern because the SGMs may fail to process traffic.

C : If correction rates are higher than 80 percent, latency is expected.

D : In some scenarios, a correction rate approaching 100 percent of all connections is not unusual. This is not usually a cause for concern as the correction mechanism is fast and efficient.

Answer: B

Question 2

What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI

A : Remote orchestrator has no empty interfaces

B : Single orchestrator environment, but configured Orchestrator amount is 2

C : One orchestrator only, but Orchestrator amount is 2 or no Sync in between orchestrators

D : No Sync between orchestrators

Answer: A

Question 3

What command should be used for collecting diagnostic information about the orchestrator?

A : cpinfo

B : asg perf -v

C : cpview

D : orch_info

Answer: A

Question 4

What is the purpose of interface bonding?

A : A bond interface can be configured for high availability redundancy.

B : A bond interface is used for passing synchronization traffic between the SGMs.

C : For load sharing which increases connection throughput above that which is possible using one physical interface.

D : A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.

Answer: D

Question 5

What Maestro component acts as a load balancer and network switch?

A : Security Switching Module (SSM)

B : Maestro Hyperscale Orchestrator (MHO)

C : Security Group (SG)

D : Security Gateway Module (SGM)

Answer: B

Page: 1 / 17

Total 83 Questions | Updated On: May 22, 2026

Add To Cart