Free Oracle 1Z0-404 Practice Exam Questions and Answers 2026

Start Learning with the Newest and 100% Free 1Z0-404 Exam Dumps Questions

Page: 1 / 15

Total 75 Questions | Updated On: Apr 02, 2026

Add To Cart

Question 1

You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media. Identify two valid configuration steps for supporting VLAN 12 (Choose two.)

A : Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

B : Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

C : Navigate to the phy-interface configuration element and configure the hip-id parameter.

D : Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

E : Navigate to the network-interface configuration element and configure the name parameter.

Answer: A,C

Question 2

A steering pool defines _____________.

A : a range of ports used to route media flows as they egress the Session Border Controller

B : an IP address and port the Session Border Controller uses for steering media to the external media server

C : an IP address and range of ports the Session Border Controller will use to declare itself as the destination for media flows in a session

D : a range of IP addresses and a pool of ports the Session Border Controller will use to declare itself as the destination for all subsequent media flows in a dialog

E : arange of IP addresses used to route media flows as they egress the Session Border Controller

Answer: C

Question 3

After configuring Header Manipulation Rules (HMRs) for topology hiding, your subsequent testing shows that the manipulation is not takingeffect. Identify two causes for this (Choose two.)

A : You have not configured the out-manipulationid parameter of the sip-interface configuration element.

B : You have not enabled policy-based realm-bridging

C : The value of the name parameter in the header-rule configuration element is different than the value of the out-manipulationid parameter in the sip-interface configuration element.

D : The value of the match-val-type parameter is not written correctly

E : The home-proxy-address value does not matchthe $LOCAL_IP value in the new-value parameter.

Answer: A,E

Question 4

Which node automatically assumes the active role when peers boot simultaneously and their health scores are equivalent in a High Availability (HA) scenario?

A : the node with the highest wancom IP address

B : the node that is configuredas secondary

C : the node that had the role of active last

D : the node with the lowest wancom IP address

E : the node with the highest round-robin score

Answer: D

Question 5

You are troubleshooting a SIP routing issue and you haveaccess to the SIP call ow processed by the Session Border Controller. Which two steps are valid for troubleshooting this type of issues? (Choose two.)

A : It is necessary to locate the SIP session to troubleshoot and check if there is a 404 Routes Not Found SIP error message.

B : It is recommended to look for 183 Session Progress SIP error messages that indicate routing issues.

C : t is recommended to check the called number by looking at the Request-URI of the INVITE message and making sure it is a validnumber to be routed.

D : It is recommended to find the CANCEL method received by the Session Border Controller which typically identifies a SIP routing issue.

E : It is necessary to find an initial INVITE received by the Session Border Controller which getsa 503 Service Unavailable SIP error message.

Answer: D,E

Page: 1 / 15

Total 75 Questions | Updated On: Apr 02, 2026

Add To Cart