100% Free Huawei H12-811_V2.0 Practice Test Questions and Answers 2026

Start Learning with the Latest and Real 100% Free Huawei H12-811_V2.0 Exam Questions

Page: 1 / 12

Total 60 Questions | Updated On: May 21, 2026

Add To Cart

Question 1

Which of the following configurations can enable connectivity between interfaces on R1 and R3? (Select all that apply)

A : [R1] ip route-static 20.1.1.0 24 10.0.0.2

B : [R1] ip route-static 20.1.1.0 24 20.1.1.2

C : [R3] ip route-static 10.0.0.0 24 20.1.1.2

D : [R3] ip route-static 10.0.0.0 24 20.1.1.1

Answer: A,D

Question 2

OSPF has five types of packets. Which type is used to notify an OSPF neighbor of its required LSAs?

A : DD

B : LSR

C : LSU

D : Hello

Answer: B

Question 3

On the network shown in the figure, GE1/0/1 and GE1/0/2 of SW1 are access interfaces, and their PVIDs are VLAN 2 and VLAN 3 respectively. GE1/0/1 of SW2 is also an access interface, and its PVID is VLAN 4. Which of the following configurations on SW1 and SW2 can ensure that data packets sent from PC1 and PC2 can reach PC3?

A : Configure GE1/0/3 of SW2 as a hybrid interface, add it to VLAN 4 in untagged mode, and retain the default PVID.

B : Configure GE1/0/3 of SW1 as a hybrid interface, add it to VLAN 2 and VLAN 3 in untagged mode, and set its PVID to VLAN 4.

C : Configure GE1/0/3 of SW2 as a trunk interface, configure it to allow packets from VLAN 4 to pass through, and set its PVID to VLAN 4.

D : Configure GE1/0/3 of SW1 as a trunk interface, configure it to allow packets from VLAN 2 and VLAN 3 to pass through, and set its PVID to VLAN 4.

Answer: B,C

Question 4

On the OSPF network shown in the figure, all IP addresses can communicate with each other. Then the following configurations are added on R1:Which IP address of S1 can successfully ping 10.2.23.3?

A : 10.1.1.1

B : 10.2.1.1

C : 10.3.1.1

D : 10.0.1.1

Answer: B

Question 5

In the figure, both PC1 and PC2 belong to VLAN 10. Interface GE1/0/1 on SW1 is a trunk interface with the default PVID, and interface GE1/0/2 on SW1 is an access interface in VLAN 10. Which of the following statements are true about the forwarding of data frames between PC1 and PC2? (Select all that apply)

A : After receiving the data frame sent from PC1 to PC2, SW1 adds the VLAN 10 tag to the data frame and then accepts the data frame.

B : SW1 accepts the data frame sent from PC1 to PC2, but discards the data frame returned from PC2 to PC1.

C : The data frame processed inside SW1 does not carry any VLAN tag.

D : SW1 removes the VLAN 10 tag from the data frame before forwarding it from GE1/0/2 to PC2.

Answer: A,D

Page: 1 / 12

Total 60 Questions | Updated On: May 21, 2026

Add To Cart