100% Free HP HPE7-A08 Practice Test Questions and Answers 2026

Start Learning with the Latest and Real 100% Free HP HPE7-A08 Exam Questions

Page: 1 / 28

Total 136 Questions | Updated On: May 24, 2026

Add To Cart

Question 1

Refer to the exhibit:The interface is configured on an HPE Aruba Networking CX 8320 for a VMware server NIC, and the server admin reports that VMware vMotion traffic on VLAN 3903 fails, but the server can ping other ports with default settings. What must be done to correct the issue based on the provided interface status and configuration?

A : Configure jumbo on VLAN 3903

B : Configure jumbo on interface 1/1/36

C : Configure MTU 9198 on interface 1/1/36

D : Configure MTU 9198 on VLAN 3903

Answer: A

Question 2

What is the recommended configuration to ensure link aggregation is consistent in a campustopology using VSX with two aggregation switches and downlinks to access switches?

A : Use the command "vsx-sync active-gateways" under the VSX context.

B : Use a custom LACP hash algorithm for improved load balancing.

C : Use the command "vsx-sync mclag-interfaces" from the global context.

D : Use the command "vsx-sync mclag-interfaces" under the VSX context.

Answer: D

Question 3

Refer to the exhibit:According to the HPE Aruba Networking VSX best practices, what would need to be changed in the configuration?

A : Replace the CX6300 [1-2]/1/49 and [1-2]/1/50 ports with SFP56 connectivity.

B : Replace the CX8325 1/1/47 and 1/1/48 ports with SFP28 connectivity.

C : Replace the CX8300 [1-2]/1/49 and [1-2]/1/50 ports with QSFP28 connectivity.

Answer: B

Question 4

An ACME company employee complained about a recent poor-quality VoIP call while moving aroundtheir office environment. HPE Aruba Networking Central reported a fair UCC score for this call whileyour VoIP engineer reported that their systems reported a MOS of 2.3. The VoIP devices areoperating over the 5GHz frequency band.What are the possible contributing factors? (Select two)

A : Recent renovations have changed the floor plan

B : The Call Admission Control level is set too low

C : BSS color mode has not been enabled

D : The client does not support U-NII-2 or U-NII-2-Extended channels

Answer: A,D

Question 5

sw-1 is the master on all VRRP instances. To test the configuration, VLAN 100 was shut on sw-1, andthen once the failover occurred, it was brought back up.What is the expected outcome?

A : sw-1 will be the master for all three VRRP instances.

B : sw-1 will only be the master for VRRP 200 and VRRP 300.

C : sw-2 will only be the master for VRRP 200 and VRRP 300.

D : sw-2 will be the master for all three VRRP instances

Answer: A

Page: 1 / 28

Total 136 Questions | Updated On: May 24, 2026

Add To Cart