Free NetApp NS0-093 Practice Exam Questions and Answers 2026

Start Learning with the Newest and 100% Free NS0-093 Exam Dumps Questions

Page: 1 / 13

Total 61 Questions | Updated On: Apr 02, 2026

Add To Cart

Question 1

What is the recommended value for disk and CPU use when you plan an upgrade?

A : less than 50%

B : less than 90%

C : less than 85%

D : less than 70%

Answer: D

Question 2

A SAS connection is reporting a single PHY down. What are the two most likely causes? (Choose two.)

A : improperly seated cable

B : outdated I/O module (IOM1 firmware

C : defective cable

D : an offline shelf in the stack

Answer: A,C

Question 3

Which RAID type provides protection against three disk failures?

A : RAID DP

B : RAID-TEC

C : RAID 5

D : RAID 4

Answer: B

Question 4

You have replaced a failed boot device. You perform boot_recovery and receive no errors. However, when the node reboots, it reports that it has no disks. What are two possible causes? (Choose two.)

A : The SAS cables were incorrectly reconnected after reinstalling the motherboard.

B : The disks that are owned by this node have been marked as failed.

C : The node is booting a lower version of ONTAP software than was last used.

D : The interconnect is down.

Answer: A

Question 5

Which command can you use to confirm successful completion of an ONTAP upgrade?

A : system controller sp upgrade show

B : cluster image show-update-progress

C : job show “jobtype upgrade

D : system node upgrade-revert upgrade-task “node “version

Answer: B

Page: 1 / 13

Total 61 Questions | Updated On: Apr 02, 2026

Add To Cart